Round Architectural Canopy - 2"

Round Architectural Canopy - 2"

2-Inch Round Architectural Canopy The 2-Inch Round Architectural Canopy is a low profile ceiling interface engineered for aircraft cable suspended LED lighting systems. With a total height of exactly 0.25 inches, this canopy minimizes visual impact at the mounting plane while providing a rigid for suspended pendant and linear fixtures. It is available in two distinct configurations: a single center hole (0.25 inch diameter) for strictly mechanical cable suspension, or a dual hole variant featuring an offset 5/16 inch aperture for parallel low voltage power routing. Constructed for direct ceiling surface mounting, this component cleanly conceals internal structural hardware and wiring junctions. Designer’s Note Specify the dual hole configuration only if you intend to run power parallel to your suspension cable at the exact same ceiling coordinate. You must ensure your electrical pass through wiring does not exceed the 5/16 inch diameter limit of the secondary aperture. This 2 inch canopy provides an extremely tight footprint. Verify that your ceiling junction box or mounting cavity can accommodate the necessary wire splices and mechanical strain relief before finalizing your layout. Do not over torque the central mounting stud during installation, as excessive compressive force will permanently deform the low profile metal housing. Quick Specs

Designer’s Note

Verify compatibility and structural clearances prior to installation.

Specifications